Bartlett Model 3K kiln controller

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Brad Walker, Tony Smith

Post Reply
Terry Gallentine
Posts: 190
Joined: Mon Jul 19, 2004 2:08 pm
Location: River Falls, WI
Contact:

Bartlett Model 3K kiln controller

Post by Terry Gallentine »

I know that there are a lot of the Bartlett RTC-1000 controllers out there but I was wondering if anyone has any experience with their Model 3K controller. I assume that it is more basic than the RTC-1000 since its cost is so much less, but my needs are basic too. I would appreciate any information.
Brad Walker
Site Admin
Posts: 1501
Joined: Fri Mar 07, 2003 9:33 pm
Location: North Carolina, USA
Contact:

Re: Bartlett Model 3K kiln controller

Post by Brad Walker »

I've used it. Like any 3 key controller, it's a lot more cumbersome to use than a 12 key. Takes a lot longer to change from one number in a program to another.

The price difference at Olympic is only $50, for that amount I would definitely pay the extra for the 12 key.
Post Reply