WarmGlass.com

I've been making some drop ring vases recently and thought it'd be easy to get some iron and bend it into a simple holder. I've discovered that metal is much more uncooperative than I anticipated and would like to know if anyone could guide me to some info on how to do it. I've tried 1/8" iron and 1/4" braising rod, heating them with a propane torch then bending them around an old piece of 2" pipe. The bends always turn out really funky instead of nice smooth round curves I envision. Any assistance would be greatly appreciated!

Pam

Try an Oxygen + acetalyne torvh, it burns hotter and gives a more needle pointed style flame tip alloing for more controlled (precise)heating, thus giving the ability to get 90 deg angles and stuff. I played with one for a while and I want one, there too kool.

you can rent the tanks by the month a nd just pay for gas , but i think you'll be stuck buying the torch part

Hope I helped,
Tyler

pipe benders at the hardware store may do what you want.

Pam wrote:I've been making some drop ring vases recently and thought it'd be easy to get some iron and bend it into a simple holder. I've discovered that metal is much more uncooperative than I anticipated and would like to know if anyone could guide me to some info on how to do it. I've tried 1/8" iron and 1/4" braising rod, heating them with a propane torch then bending them around an old piece of 2" pipe. The bends always turn out really funky instead of nice smooth round curves I envision. Any assistance would be greatly appreciated!

Pam

Ask a blacksmith shop to make them.

Hi- welding material suppliers can sell circles of many diameters. Squares, too. Ask King Architectural Metals for help or maybe a closer supplier. They are in Dallas, Baltimore, and LA.

The simplest way is to get a piece of pipe the size you want, clamp your stock (vise grip) to one end and coil up a length. Cut the coils and your home free...well except for the welding, clean up and painting.
Dick

I use Bert's method. My local smith makes rings for me at about $5 each.

I prefer using inexpensive benders for truely smoothe curves. Http://www.harborfreight.com has a couple of products that will bend or make rings. Item #36790-0VGA Planetary Ring Roller will make rings from 3" to several feet in diameter. This tool is $49.99 and is suitable for modest use. They also have a general purpose bender that sells for about $79.00.

Thanks to all for the good advice. Before I give up and have someone make them for me I'l try the planetary ring tool and finding out more about the best kind of metal. Will post the results if I'm successful!