This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.
Moderators: Brad Walker , Tony Smith
Greg Rawls
Posts: 147 Joined: Sun Mar 09, 2003 8:11 pm
Location: Charleston, SC
Contact:
Post
by Greg Rawls » Sat Jun 28, 2003 7:33 am
A piece I fused developed a crack while cold working (guess I got a little rough!). You can not see the crack, but you can feel it. The piece is 1/2" thick. I'd like some suggestions on a firing schedule to heal the crack. I will re-dam the glass prior to firing. How far up should I go? Do I have to go to a full fuse or can I get away with a lower temp? Many thanks in advance folks!
Greg
Brock
Posts: 1519 Joined: Mon Mar 10, 2003 1:32 pm
Location: Vancouver, B.C.
Post
by Brock » Sat Jun 28, 2003 7:59 am
You'll have to go back to a full fuse. Brock
My memory is so good, I can't remember the last time I forgot something . . .
Greg Rawls
Posts: 147 Joined: Sun Mar 09, 2003 8:11 pm
Location: Charleston, SC
Contact:
Post
by Greg Rawls » Sat Jun 28, 2003 1:39 pm
THanks Brock!
Greg
charlie
Posts: 961 Joined: Mon Mar 10, 2003 3:08 pm
Post
by charlie » Mon Jun 30, 2003 10:33 am
Brock wrote: You'll have to go back to a full fuse. Brock
and heat it slower, as it'll thermal shock easier and the crack may propagate further. damhikt.
Greg Rawls
Posts: 147 Joined: Sun Mar 09, 2003 8:11 pm
Location: Charleston, SC
Contact:
Post
by Greg Rawls » Mon Jun 30, 2003 7:37 pm
Did exactly that and the crack healed nicely. This is one piece that is NOT destine to be frit!
Greg