WarmGlass.com

Hi Ron,
Thank you for the link.
I copied quite a bit of info. down from there.
Unfortunately, I cannot find out ramping up/down info involving
their controller and cannot even find out who makes the controller
for that kiln.
Sounds like I am out of luck.
Maybe I will look on line and in the archives
for 4 segment general controller information and try to
apply that to running the 4th application, the programmable
application for the Sierra Kiln controller. I have already learned
much thanks to the link you gave me!
Regards,
Ruth Elfering

Hi Ruth

I'll bet good money and say the controller was made by Orton. One of the board sponsors.


This will take you to their listing of current controllers.
http://www.ortonceramic.com/Firing/cont ... ature.html

There is a BooBoo in the links to some of the manual pdf files.

These will get you to the files

Jewelery controller

http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf

Cone fire controller

http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf

Speed controller

http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf

Ramp/hold controller

http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf

Hope this helps

Ron

Thanks again Ron!
You sure shortened my search time!
Take care!
Ruth!