WarmGlass.com

Hello again

I would like to know more about different kind of board (Fiber Board,Ceraboard etc) avaible in the market and what are the difference (and their meaning : i.e. Density? ecc)

Anyway i found different instructions and different schedule temp for hardnering and non all tell about be carefull about Flash Point.
Plaese can somebody light me more ?...i am a lot confused...

thanks in advance.

regards,

mike from italy

ciao

Fiber boards are rated by density, HD-high density, MD-medium density, and LD-low density.

There are 2 very different kinds of hardeners, colloidal alumina and colloidal silica. The colloidal silica is more effective, tends to stay on the surface, and is very sticky to glass, so needs to be kilnwashed. This liquid will become useless if frozen, so you can not purchase it in winter in places where shipping will freeze it. Colloidal alumina can be bought as a powder and mixed with water. It tends to sink in, and acts as a separator, but not for long.

I have never hardened a board I bought, and hope to never have to. I buy what I want, and use it.

Bert ,excellent reply. thank you.
I had no idea before.


why choose different density ?


grazie
ciao

mikefromitaly wrote:Bert ,excellent reply. thank you.
I had no idea before.


why choose different density ?


grazie
ciao

Lower density has higher insulating values. Higher density has greater strength. I line my kilns with HD board, and also prefer those boards for shelves.

thank u Bert

i read more values in the Technical Sheet of Boards.. are important as insulating and strenght ?

ciao