Bullseye schedules
Posted: Mon Aug 03, 2015 12:55 pm
Hi all,
I am going to have a go at fusing some coarse frit in Kaiser board molds to create pattern bars. My bars will end up 10cm x 4cm x 4cm. Is there a way I can calculate the fusing schedule for these size pieces as I will be firing 12 of them and don't want to mess it up. I have never done anything thicker than a 6mm platter.
I have looked at the Bullseye site but can't find an answer for this particular size. Is there a brilliant table like the potmelt one that calculates it once you enter the sizes.
Many thanks
Tracey
I am going to have a go at fusing some coarse frit in Kaiser board molds to create pattern bars. My bars will end up 10cm x 4cm x 4cm. Is there a way I can calculate the fusing schedule for these size pieces as I will be firing 12 of them and don't want to mess it up. I have never done anything thicker than a 6mm platter.
I have looked at the Bullseye site but can't find an answer for this particular size. Is there a brilliant table like the potmelt one that calculates it once you enter the sizes.
Many thanks
Tracey