Page 1 of 1
Remove imperfections on fused piece
Posted: Sun May 04, 2003 10:59 pm
by Jack Miller
Have fired a tray and it has several spots resembling water spots or devit. Can these be sanded and then refired? Or polished out? Thx, Jack
Re: Remove imperfections on fused piece
Posted: Mon May 05, 2003 5:50 am
by Brian and Jenny Blanthorn
Jack Miller wrote:Have fired a tray and it has several spots resembling water spots or devit. Can these be sanded and then refired? Or polished out? Thx, Jack
Yes n yes
There is a lot on this
Try a search polishing
Fire Polishing
Re: Remove imperfections on fused piece
Posted: Mon May 05, 2003 9:33 am
by Jerry Barnett
Jack Miller wrote:Have fired a tray and it has several spots resembling water spots or devit. Can these be sanded and then refired? Or polished out? Thx, Jack
I have not had enough occasions to be sure that this works every time, but have had refiring with Super Spray overglaze remove the white outline of water spots and/or light hazing on the glass surface. Jerry
Posted: Mon May 05, 2003 8:59 pm
by Dick Ditore
sandblast and refire. If you are using thinfire, don't.
Dick